How to create Winglets

How to create Winglets

To create Winglets

Step 1

To create the Winglets, the first thing you need to draw a box ( x ) with Segment Z to 2.

Top view

Right view

Step 2

Later, you need to select the points and move ( t ) it higher.

Step 3

After that, create a box in the same layer and press Enter to confirm the setting.

Right view

Back view

Step 4

Select the box in polygons selection mode and move ( t ) it right side.

Step 5

Now, you need to mirror the selected object.

Step 6

Select the points and move it higher.

Step 7

Deselect the points and draw another box as shown below, then press Enter.

Back view

Right view

Step 8

Finally, a Formula 1 car has been completed.

Edited By: Norasyikin Mahmud

© 2001 ISC/Inner Esteem

All rights reserved. All other product names and trademarks are registered properties of their respective owners.

301001

How to subtract object

How to subtract object

To subtract object

Step 1

To subtract the object, the first thing you need to do is to draw a box ( x ) in a new layer and press Enter.

Top view

Right view

Step 2

After that, you need to select the object that you want to Boolean as front layer and put the box as back layer.

Step 3

Next, activate the Boolean tool ( B ) and select the Subtract for Operation and press OK.

How to mirror object

How to mirror object

To mirror object

Step 1

To mirror the object, the first thing you need to do is to activate the mirror tool ( V ) and bring out the numeric panel ( n ). Later, you have to close the panel and press Enter.

Step 2

Next, the result will be shown as below.

How to create the pushrod

How to create the pushrod

To create the pushrod

Step 1

If you would like to create the pushrod, the first thing you need to do is to press + to create points. Then, click the right mouse button and just click at every spot you wish to create point.

Step 2

Next, you need to press the p key to create the polygon.

Step 3

Later, you ought to select the polygon in polygons selection mode.

Step 4

You need to extrude ( E ) the polygon and press Enter.

Step 5

Then, move ( t ) the object higher.